Solid G und T-Rex 500

[Knut T.]

Hallo allerseits,
Ich bin gerade auf der Suche nach der optimalen Einstellung des Solid G auf den T-Rex 500. Vielleicht fliegt jemand von Euch ja auch diese Kombination. Als Heckservo hab ich Futaba 9257. Bisher wackelt das Heck im Schwebeflug leicht hin und her. Als Modell hab ich den T-Rex 600E ausgewählt. Servo F9253/JR8900G; Gain 38%; Kopfdrehzahl 2600/min. Original Regler u. Motor im Stellermode.
Meine Einstellung bisher:
LS Speed 60
RS Speed 60
L-FastSp 15
R-FastSp 30
L-Coast 40
R-Coast 50
Pir-Speed 38
Pir Balance 48
Gain Balance 48
Rate Gain 25
Head Gain 45
Expo 80 u. Expo Width 30
Head Lin 100

Vielen Dank für Eure Mühe

Gruß Knut

[makroa1]

AW: Solid G und T-Rex 500

Hi, hier von der Curtis Youngblood Seite:

Solid G parameters for T-rex 500 (using model set on Trex 600E settings, all settings shown not just the changed ones)
These settings optimize the Trex500 with stock plastic tail blades. See photo under main product photo for mounting location of gyro and ESC. Best performance was with the gyro on bottom tray and ESC up in front beside the battery.

Pirouette Menu
Lft Stp Spd 50
Rgt Stp Speed 36
Lftfststpspd 25
rgtfststpspd 25
Lft Cst/Rbd 80
Right Cst/Rbd 80

Response Menu
Pir Speed 55
Pir balance 43
Gain Balance 40
Rate Gain 25
Heading Gain 45
Pir Gain 15

Trex 500 Note 1.) note with these settings I have been flying with a G-view reading gain of 44% using a JR3400 tail servo set on 9253/8900G servo option. But many things affect this gain setting. To improve tail hold I had to glue the horizontal fin clamp to the boom (otherwise it was loose in flight). I also reamed out the tail blade grips until the thrust bearings fell into the grips loose (they come tight and tend to lock up in flight).

Trex500 Note 2.) I used the stock 500 ESC but moved it all the way to the front up by the battery to prevent noise into the radio system. Some people have had to use seperate BECs to reduce noise hits in their radio system (this affects other radios and gyros, not just the Solid G) on the Trex 500.

Trex500 Note 3.) An expo setting of about 40% seems to give a feel around center that most pilot like. With no expo the tail is very responsive around center. I (Curtis) like it with no expo, but most people prefer about 40%.

Liebe Grüsse, Christoph