ring nt frage

[ferry]

hello, i am rebuilding my nt rotorhead after ein absturtz :[
can somebody tell me , the nt ring what goes under the swash , how high in mm is it ?
i dont have it , and i need the measure for adjusting the connecting rods
thanks in advantage , ferry

[DirkS]

AW: ring nt frage

Hi Ferry,
the ring is 18,5mm high. Inner diameter is 36mm.

Dirk

[ferry]

AW: ring nt frage

ah , danke dirk fur die snelle reply !!
gruss ferry

[ferry]

AW: ring nt frage

guys , im a bit confused.
is it right to put a 18.5 mm ring under the taumel , and then make all the links so , that the blades are 0 degrees and the mfs /paddelstange , is in the middel of the slot ?
if so , please tell me .
gruss ferry

[ferry]

AW: ring nt frage

ok , something is not wright with the 18.5mm ring .
i made a ring , but 18.5 mm is too high for 0 degrees pitch , if i give negative pitch it can only go 2 more mm untill the taumel hits the headblock.
can someone give me measurements of the links on the head ?
regards ferry

[Paulh]

AW: ring nt frage

ik heb een PB gestuurd.

[DirkS]

AW: ring nt frage

Hi Ferry,
you can download the manual for the NT here.

On page 14 you will find the length for the pushrods.

Gruß

Dirk

[ferry]

AW: ring nt frage

i got it .
it is the same as the mp ring
only difference is , that the nt ring is higher , but it is wider and therefore rests on the outer seat of the swash.
while the mp ring is thinner , but it rests on the inner ring .
it works out to be the same , you can use eiteher ring .
i got confused becouse i saw on the henseleit site , that the partnumber for the nt ring and mp ring are the same .
it works beautifully now , i lopve the nt !!
thanks people!